D-Link DGS-3700 Series Reference Manual page 542

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
show ethernet_oam ports status
Parameters
Restrictions
Example usage:
To show OAM control and status information on port 1-2:
DGS-3700-12:5#show ethernet_oam ports 1-2 status
DGS-3700-12:5#show ethernet_oam ports 1-2 status
Port 1
Local Client
-----------------------------------------------------------
OAM
Mode
Max OAMPDU
Remote Loopback
Unidirection
Link Monitoring
Variable Request
PDU Revision
Operation Status
Loopback Status
There is no peer entry information exist !
Port 2
Local Client
-----------------------------------------------------------
OAM
Mode
Max OAMPDU
Remote Loopback
Unidirection
CTRL+C ESC q Quit
show ethernet_oam ports configuration
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show Ethernet OAM configuration on port 1-2:
At present, only loop-back, link monitoring, and unidirectional are supported.
portlist – Specifies a range of ports to display.
None
: Enabled
: Passive
: 1518
: Support
: Not Supported
: Support
: Not Supported
: 1
: LinkFault
: No Loopback
: Disabled
: Active
: 1518
: Support
: Not Supported
SPACE n Next Page
Used to display Ethernet OAM configuration.
show ethernet_oam ports {<portlist>} configuration
The command is used to show port's Ethernet OAM configurations.
portlist – Specifies a range of ports to display.
None.
Bytes
Bytes
ENTER Next Entry a
Page | 542
All