Q-In-Q Commands - D-Link DGS-3700 Series Reference Manual

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
Q- -Q C
IN OMMANDS
Back to Section Header
The Q-in-Q commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
C
OMMAND
enable qinq
config qinq ports
disable qinq
show qinq
show qinq ports
create vlan_translation ports
delete vlan_translation ports
show vlan_translation
config qinq inner_tpid
show qinq inner_tpid
Each command is listed, in detail, in the following sections.
enable qinq
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable Q-in-Q:
DGS-3700-12:5#enable qinq
Command: enable qinq
Success.
DGS-3700-12:5#
P
ARAMETERS
[<portlist>|all] {role [uni | nni] | missdrop [enable | disable]| outer_tpid
<hex 0x1 - 0xffff>| use_inner_priority [enable|disable]| add_inner_tag
[<hex 0x1 - 0xffff> |disable]}(1)
{<portlist>}
[<portlist> | all] [add cvid <vidlist> | replace cvid <vlanid 1-4094>] svid
<vlanid 1-4094> {priority <value 0-7>}
[<portlist> | all] {cvid <vidlist>}
{[ports <portlist> | cvid <vidlist> | hardware]}
<hex 0x1 – 0xffff>
Used to enable Q-in-Q mode.
enable qinq
This command enables Q-in-Q mode.
When enable Q-in-Q, all network port roles will be NNI port and their outer TPID
will be set to 88A8. All existed static VLAN will run as SP-VLAN. All
dynamically learned L2 address will be cleared. All dynamically registered VLAN
entries will be cleared, GVRP will be disabled.
If you need to run GVRP on the switch, you shall enable GVRP manually. In Q-in-Q
mode, the GVRP PDU address is configurable. By default, the PDU address
defined in 802.1ad (01-80-C2-00-00-0D)The default setting of Q-in-Q is disabled.
None.
Only Administrator and Operator-level users can issue this command.
Page | 283