D-Link DGS-3700 Series Reference Manual page 453

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
DGS-3700-12G:5#config mac_based_access_control log state disable
Command: config mac_based_access_control log state disable
Success.
DGS-3700-12G:5#
config mac_based_access_control trap
Purpose
Syntax
Description
Parameters
Restrictions
Example usage
To enable trap state of MAC-based Access Control:
DGS-3700-12G:5#config mac_based_access_control trap state enable
Command: config mac_based_access_control trap state enable
Success.
DGS-3700-12G:5#
config mac_based_access_control max_users
Purpose
Syntax
Description
Parameters
Restrictions
Example usage
To configure the maximum number of users of the MAC-based Access Control system supports to 128:
DGS-3700-12G:5#config mac_based_access_control max_users 128
Command: config mac_based_access_control max_users 128
Success.
DGS-3700-12G:5#
This command is used to enable or disable sending of MAC-based Access Control
traps.
config mac_based_access_control trap state [enable | disable]
This command is used to enable or disable sending of MAC-based Access Control
traps.
enable - Enable trap for MAC-based Access Control. The trap of MAC-based Access
Control will be sent out.
disable - Disable trap for MAC-based Access Control.
Only Administrator and Operator-level users can issue this command.
This command is used to configure the maximum number of authorized clients.
config mac_based_access_control max_users [<value 1 - 1000> | no_limit]
This command is used to configure the maximum number of authorized clients.
max_users - Specify to set the maximum number of authorized clients on the whole
device.
<value 1-1000> - Enter the maximum users here. This value must be between 1 and
1000.
no_limit - Specify to not limit the maximum number of users on the system. By
default, there is no limit on the number of users.
Only Administrator and Operator-level users can issue this command.
Page | 453