D-Link DGS-3700 Series Reference Manual page 451

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
DGS-3700-12:5#clear mac_based_access_control auth_state ports all
Command: clear mac_based_access_control auth_state ports all
Success.
DGS-3700-12:5#
config mac_based_access_control max_users
Purpose
Syntax
Description
Parameters
Restrictions
Example usage
To configure the MAC-based access control maximum number of authorized users:
DGS-3700-12:5#config mac_based_access_control max_users 2
Command: config mac_based_access_control max_users 2
Success.
DGS-3700-12:5#
config mac_based_access_control authorization attributes
Purpose
Syntax
Description
Parameters
Restrictions
To configure the MAC-based access control maximum number of authorized users.
config mac_based_access_control max_users [<value 1-1000> | no_limit]
This command is used to configure the MAC-based access control maximum number
of authorized users.
<value 1-1000> - Specify the maximum number of authorized users.
no_limit - Specify an unlimited number of authorized users.
Only Administrator and Operator-level users can issue this command.
To enable or disable the acceptance of an authorized configuration.
config mac_based_access_control authorization attributes {radius [enable |
disable] | local [enable | disable]}
This command is used to enable or disable the acceptance of an authorized
configuration. When authorization is enabled for MAC-based access controls with
RADIUS authentication, the authorized attributes (for example VLAN, 802.1p
default priority, and ACL) assigned by the RADUIS server will be accepted if the
global authorization status is enabled. When authorization is enabled for MAC-
based access controls with local authentication, the authorized attributes assigned
by the local database will be accepted.
radius - See below:
enable - If specified to enable, the authorized attributes (for example VLAN,
802.1p default priority, and ACL) assigned by the RADUIS server will be
accepted if the global authorization status is enabled. The default state is
enabled.
disable - If specified to disable, the authorized attributes (for example VLAN,
802.1p default priority, and ACL) assigned by the RADUIS server will not be
accepted if the global authorization status is disabled.
local - See below:
enable - If specified to enable, the authorized attributes assigned by the local
database will be accepted if the global authorization status is enabled. The
default state is enabled.
disable - If specified to disable, the authorized attributes assigned by the local
database will not be accepted if the global authorization status is disabled.
Only Administrator and Operator-level users can issue this command.
Page | 451