D-Link DGS-3700 Series Reference Manual page 508

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
Example usage:
To display dynamic binding entries for "engineering":
DGS-3700-12:5#show dhcp pool engineering
Command: show dhcp pool engineering
Pool Name
Network Address
Domain Name
DNS Server
NetBIOS Name Server : 10.10.10.1
NetBIOS Node Type : broadcast
Default Router
Pool Lease
Boot File
Next Server
DGS-3700-12:5#
show dhcp pool manual_binding
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the configured manual binding entries:
DGS-3700-12:5#show dhcp pool manual_binding
Command: config dhcp pool manual_binding
Pool Name IP Address
------------ ------------- ------------------ --------
p1 192.168.0.1
p1 192.168.0.2
Total Entries : 2
DGS-3700-12:5#
enable dhcp_server
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
: engineering
: 10.10.10.0/24
: dlink.com
: 10.10.10.1
: 10.10.10.1
: 10 days, 0 hours, 0 minutes
: boot.bin
: 10.10.10.2
Used to display the current DHCP Server manual binding.
show dhcp pool manual_binding {<pool_name 12>}
This command is used to display the configured manual binding entries.
<pool_name 12> - Specify a DHCP pool name.
None.
Hardware Address
00-80-C8-08-13-88
00-80-C8-08-13-99
Used to enable the DHCP Server function on the switch.
enable dhcp_server
If DHCP relay is enabled, DHCP server cannot be enabled. The opposite is also true.
For Layer 2 switches, if DHCP client is enabled on the only interface, then DHCP
server cannot be enabled. For layer 3 switches, if DHCP client is enabled on an
interface, the DHCP server can be enabled. However, DHCP server will not service
the packet that is received from this interface.
None.
Only Administrator-level users can issue this command.
Type
Ethernet
Ethernet
Page | 508