D-Link DGS-3700 Series Reference Manual page 263

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
config stp instance_id
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure instance ID 2 to add VID 10:
DGS-3700-12:5#config stp instance_id 2 add_vlan 10
Command : config stp instance_id 2 add_vlan 10
Success.
DGS-3700-12:5#
Example usage:
To remove VID 10 from instance ID 2:
DGS-3700-12:5#config stp instance_id 2 remove_vlan 10
Command : config stp instance_id 2 remove_vlan 10
Success.
DGS-3700-12:5#
delete stp instance_id
Purpose
Syntax
Description
Parameters
Restrictions
Used to add or delete VID to/from an STP instance.
config stp instance_id <value 1-15> [add_vlan | remove_vlan] <vidlist>
This command is used to map VIDs (VLAN IDs) to previously configured STP
instances on the Switch by creating an instance_id. A STP instance may have
multiple members with the same MSTP configuration. There is no limit to the
number of STP regions in a network but each region only supports a maximum of
16 spanning tree instances (one unchangeable default entry). VIDs can belong to
only one spanning tree instance at a time.
NOTE: Switches in the same spanning tree region having the same
STP instance_id must be mapped identically, and have the same
configuration revision_level number and the same name.
<value 1-15> − Enter a number between 1 and 15 to define the instance_id. The
Switch supports 16 STP instances with one unchangeable default instance ID set as
0.
add_vlan – Along with the vid_range <vidlist> parameter, this command will add
VIDs to the previously configured STP instance_id.
remove_vlan − Along with the vid_range <vidlist> parameter, this command will
remove VIDs to the previously configured STP instance_id.
<vidlist> − Specify the VID range from configured VLANs set on the Switch.
Supported VIDs on the Switch range from ID number 1 to 4094.
Only Administrator and Operator-level users can issue this command.
Used to delete a STP instance ID from the Switch.
delete stp instance_id <value 1-15>
This command allows the user to delete a previously configured STP instance ID from
the Switch.
<value 1-15> − Enter a value between 1 and 15 to identify the Spanning Tree instance
on the Switch.
Only Administrator and Operator-level users can issue this command.
Page | 263