D-Link DGS-3700 Series Reference Manual page 527

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
show cfm mepname mep1
Command: show cfm mepname mep1
Name
MEPID
Port
Direction
CFM Port Status
MAC Address
MEP State
CCM State
PDU Priority
Fault Alarm
Alarm Time
Alarm Reset Time
Highest Fault
AIS State
AIS Period
AIS Client Level
AIS Status
LCK State
LCK Period
LCK Client Level
LCK Status
Out-of-Sequence CCMs: 0 received
Cross-connect CCMs
Error CCMs
Normal CCMs
Port Status CCMs
If Status CCMs
CCMs transmitted
In-order LBRs
Out-of-order LBRs
Next LTM Trans ID
Unexpected LTRs
LBMs Transmitted
AIS PDUs
AIS PDUs Transmitted: 0
LCK PDUs
LCK PDUs Transmitted: 0
DGS-3700-12G:5#
show cfm fault
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display CFM fault:
: mep1
: 1
: 1
: Inward
: Disabled
: 00-21-91-AF-3C-08
: Disabled
: Disabled
: 7
: Disabled
: 250 centisecond((1/100)s)
: 1000 centisecond((1/100)s)
: None
: Disabled
: 1 Second
: Invalid
: Not Detected
: Disabled
: 1 Second
: Invalid
: Not Detected
: 0 received
: 0 received
: 0 received
: 0 received
: 0 received
: 0
: 0 received
: 0 received
: 0
: 0 received
: 0
: 0 received
: 0 received
This command is used to show fault MEPs.
show cfm fault {md <string 22> {ma <string 22>}}
This command is used to display all the fault conditions detected by the MEPs
contained in the specified MA or MD. This display provides the overview of fault
status by MEPs.
md – Specifies the maintenance domain name.
ma – Specifies the maintenance association name.
None.
Page | 527