D-Link DGS-3700 Series Reference Manual page 107

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
Model Name
Asset ID
DGS-3700-12:5#
show lldp local_ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display LLDP local port information for port 1:
DGS-3700-12:5#show lldp local_ports 1
Command: show lldp local_ports 1
Port ID : 1
-----------------------------------------------------------------------------
Port ID Subtype
Port ID
Port Description
Port PVID
Management Address Count
PPVID Entries Count
VLAN Name Entries Count
Protocol Identity Entries Count
MAC/PHY Configuration/Status
Link Aggregation
Maximum Frame Size
DGS-3700-12:5#
show lldp mgt_addr
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the LLDP management address:
To display the per-port information currently available for populating outbound LLDP
advertisements.
show lldp local_ports {<portlist>} {mode [brief | normal | detailed]}
Use this command to display the per-port information currently available for
populating outbound LLDP advertisements.
<portlist> - Specify the ports to be displayed. When a port list is not specified,
information for all ports will be displayed.
mode - See below:
brief - Specify to display the information in brief mode.
normal - Specify to display the information in normal mode. This is the default
display mode.
detailed - Specify to display the information in detailed mode.
None.
To display the LLDP management address.
show lldp mgt_addr {[ipv4 <ipaddr> | ipv6 <ipv6addr>]}
Use this command to display the LLDP management address.
ipv4 - Specify the IPv4 address of the LLDP managament address entry.
ipv6 - Specify the IPv6 address of the LLDP managament address entry.
None.
:
:
: MAC Address
: 00-01-02-03-04-80
: D-Link DGS-3700-12 R2.00.B023 Po
rt 1 on Unit 1
: 1
: 1
: 0
: 1
: 0
: (See Detail)
: (See Detail)
: 1536
Page | 107