Dhcp Server Commands - D-Link DGS-3700 Series Reference Manual

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
DHCP S
ERVER
Back to Section Header
The DHCP Server commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
C
OMMAND
create dhcp excluded_address
begin_address
delete dhcp excluded_address
show dhcp excluded_address
create dhcp pool
delete dhcp pool
config dhcp pool network_addr
config dhcp pool
domain_name
config dhcp pool dns_server
config dhcp pool
netbios_name_server
config dhcp pool
netbios_node_type
config dhcp pool
default_router
config dhcp pool lease
config dhcp pool boot_file
config dhcp pool next_server
config dhcp ping_packets
config dhcp ping_timeout
create dhcp pool
manual_binding
delete dhcp pool
manual_binding
clear dhcp binding
show dhcp binding
show dhcp pool
show dhcp pool
manual_binding
enable dhcp_server
disable dhcp_server
show dhcp_server
clear dhcp conflict_ip
show dhcp conflict_ip
Each command is listed, in detail, in the following sections.
C
OMMANDS
P
ARAMETERS
<ipaddr> end_address <ipaddr>
[begin_address <ipaddr> end_address <ipaddr> | all]
<pool_name 12>
[<pool_name 12> | all]
<pool_name 12> <network_address>
<pool_name 12> {<domain_name 64>}
<pool_name 12> {<ipaddr>} {<ipaddr>} {<ipaddr>}
<pool_name 12> {<ipaddr>} {<ipaddr>} {<ipaddr>}
<pool_name 12> [broadcast | peer_to_peer | mixed |hybrid]
<pool_name 12> {<ipaddr>} {<ipaddr>} {<ipaddr>}
<pool_name 12> [<day 0-365> <hour 0-23> <minute 0-59> | infinite]
<pool_name 12> {<file_name 64>}
<pool_name 12> {<ipaddr>}
<number 0-10>
<millisecond 10-2000>
<pool name 12> <ipaddr> hardware_address <macaddr> {type [Ethernet
| IEEE802]}
<pool_name 12> [<ipaddr> | all]
[<pool_name 12> [<ipaddr> | all] | all]
{<pool_name 12>}
{<pool_name 12>}
{<pool_name 12>}
[<ipaddr> | all]
{<ipaddr>}
Page | 498