D-Link DGS-3700 Series Reference Manual page 195

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
create igmp_snooping multicast_vlan
Parameters
Restrictions
Example usage:
To create IGMP multicast VLAN RG 11:
DGS-3700-12:5# create igmp_snooping multicast_vlan RG 11
Command: create igmp_snooping multicast_vlan RG 11
Success.
DGS-3700-12:5#
config igmp_snooping multicast_vlan
Purpose
Syntax
Description
Parameters
<vlan_name> − The name of the VLAN to be created. Each multicast VLAN is given
a name that can be up to 32 characters.
vlanid – The VLAN ID of the multicast VLAN to be create. The range is 2-4094
remap_priority
• <value 0-7> - Specify the remap priority (0 to 7) to be associated with the data
traffic to be forwarded on the multicast VLAN.
• none - If none is specified, the packet's original priority will be used. The
default setting is none.
replace_priority - Specify that the packet's priority will be changed by the switch,
based on the remap priority. This flag will only take effect when the remap priority
is set.
Only Administrator and Operator-level users can issue this command.
Used to configure the parameter of the specific IGMP multicast VLAN.
config igmp_snooping multicast_vlan <vlan_name 32> {[add | delete]
[member_port <portlist> | [source_port <portlist> | untag_source_port
<portlist>] | tag_member_port <portlist>]| state [enable |disable]
|replace_source_ip <ipaddr> | remap_priority [<value 0-7> | none]
{ replace_priority}}(1)
This command allows you to add a member port, add a tag member port, and add a
source port to the port list. The member port will automatically become the
untagged member of the IGMP multicast VLAN, the tag member port and the
source port will automatically become the tagged member of the IGMP multicast
VLAN. To change the port list, the new port list will replace the previous port list if
the add or delete is not specified.
The member port list and source port list can not overlap. However, the member port
of one IGMP multicast VLAN can overlap with another IGMP multicast VLAN.
The IGMP multicast VLAN must be created first before configuration.
<vlan_name> − The name of the VLAN to be created. Each multicast VLAN is given
a name that can be up to 32 characters.
member_port – A range of member ports to add to the multicast VLAN. They will
become the untagged member port of the IGMP multicast VLAN.
untag_source_port - Specify the source port or range of source ports as untagged
members of the multicast VLAN. The PVID of the untagged source port is
automatically changed to the multicast VLAN. Source ports must be either tagged
or untagged for any single multicast VLAN, i.e. both types cannot be members of
the same multicast VLAN
tag_member_port − Specifies the tagged member port of the IGMP multicast VLAN.
source_port − A range of source ports to add to the multicast VLAN.
state − enable or disable multicast VLAN for the chosen VLAN.
Page | 195