D-Link DGS-3700 Series Reference Manual page 461

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
To enable SSH:
DGS-3700-12G:5#enable ssh
Command: enable ssh
TELNET will be disabled when enable SSH.
Success.
DGS-3700-12G:5#
disable ssh
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
To disable SSH:
DGS-3700-12:5#disable ssh
Command: disable ssh
Success.
DGS-3700-12:5#
config ssh authmode
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the SSH authentication mode by password:
Used to disable SSH.
disable ssh
This command allows users to disable SSH on the Switch.
None.
Only Administrator and Operator-level users can issue this command.
Used to configure the SSH authentication mode setting.
config ssh authmode [password | publickey | hostbased] [enable | disable]
This command is used to configure the SSH authentication mode for users attempting
to access the Switch.
password – This parameter may be chosen if the administrator wishes to use a locally
configured password for authentication on the Switch.
publickey − This parameter may be chosen if the administrator wishes to use a
publickey configuration set on a SSH server, for authentication.
hostbased − This parameter may be chosen if the administrator wishes to use a host
computer for authentication. This parameter is intended for Linux users requiring
SSH authentication techniques and the host computer is running the Linux
operating system with a SSH program previously installed.
[enable | disable] − This allows users to enable or disable SSH authentication on the
Switch.
Only Administrator and Operator-level users can issue this command.
Page | 461