Password Recovery Commands - D-Link DGS-3700 Series Reference Manual

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
P R
ASSWORD
Back to Section Header
The switch password recovery commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
C
OMMAND
reset config
reboot
reset account
reset password
show account
Each command is listed, in detail, in the following sections.
NOTE: All Password revovery commands can be executed in password revovery mode. If
you wish to enter the Switch into password recovery mode, simply press " ^ "after the system
has booted up successfully and loaded the runtime image to 100%.
Boot Procedure
--------------------------------------------------------------------
Power On Self Test.................................100%
MAC Address : 00-80-C2-11-22-00
H/W Version : A1
Please wait, loading V2.00.B023 Runtime image......100%
Password Recovery Mode
>_
reset config
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To reset the configuration:
>reset config
Command: reset config
Are you sure want to reset current configuration?(y/n) y
Success.
reboot
Purpose
C
ECOVERY OMMANDS
P
ARAMETERS
{force_agree}
{force_agree}
{<username>}
Used to reset the configuration .
reset config { force_agree }
This command is used to reset the configuration parameters. The configuration is reset
but not saved.
force_agree: if this parameter is specified, there will not be the prompt message to ask
for user's confirmation.
None.
Used to exit Reset Configuration Mode and restart the switch.
V1.00.B002
Page | 48