D-Link DGS-3700 Series Reference Manual page 415

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
DGS-3700-12:5#config authen application http login default
Command: config authen application http login default
Success.
DGS-3700-12:5#
show authen application
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the login and enable method list for all applications on the Switch:
DGS-3700-12:5#show authen application
Command: show authen application
Application Login Method List
-------------- ----------------
Console default
Telnet Trinity
SSH default
HTTP default
DGS-3700-12:5#
create authen server_host
Purpose
Syntax
Description
Parameters
Used to display authentication methods for the various applications on the Switch.
show authen application
This command will display all of the authentication method lists (login, enable
administrator privileges) for Switch configuration applications (console, telnet,
SSH, web) currently configured on the Switch.
None.
Only Administrator-level users can issue this command.
Enable Method List
-----------------------
Used to create an authentication server host.
create authen server_host <ipaddr> protocol [tacacs | xtacacs | tacacs+ | radius]
{port <int 1-65535> | key [<key_string 254> | none] | timeout <int 1-255> |
retransmit < 1-20>}
This command will create an authentication server host for the
TACACS/XTACACS/TACACS+/RADIUS security protocols on the Switch. When
a user attempts to access the Switch with authentication protocol enabled, the
Switch will send authentication packets to a remote
TACACS/XTACACS/TACACS+/RADIUS server host on a remote host. The
TACACS/XTACACS/TACACS+/RADIUS server host will then verify or deny the
request and return the appropriate message to the Switch. More than one
authentication protocol can be run on the same physical server host but, remember
that TACACS/XTACACS/TACACS+/RADIUS are separate entities and are not
compatible with each other. The maximum supported number of server hosts is 16.
server_host <ipaddr> − The IP address of the remote server host to add.
protocol – The protocol used by the server host. The user may choose one of the
following:
tacacs – Enter this parameter if the server host utilizes the TACACS protocol.
xtacacs − Enter this parameter if the server host utilizes the XTACACS protocol.
tacacs+ − Enter this parameter if the server host utilizes the TACACS+ protocol.
default
default
default
default
Page | 415