D-Link DGS-3700 Series Reference Manual page 304

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
config port_vlan
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To set the ingress checking status, the sending and receiving GVRP information:
DGS-3700-12:5#config port_vlan 1-4 gvrp_state enable ingress_checking enable
acceptable_frame tagged_only pvid 2
Command: config port_vlan 1-4 gvrp_state enable ingress_checking enable
acceptable_frame tagged_only pvid 2
Success.
DGS-3700-12:5#
enable gvrp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the Generic VLAN Registration Protocol (GVRP):
Used to configure GVRP status, ingress checking acceptable frame and PVID per
port.
config port_vlan [<portlist> | all] {gvrp_state [enable | disable] | ingress_checking
[enable | disable] | acceptable_frame [tagged_only | admit_all] | pvid <vlanid
1- 4094>} (1)
This command is used to configure the Group VLAN Registration Protocol on the
Switch. Ingress checking, the sending and receiving of GVRP information, and the
Port VLAN ID (PVID) can be configured.
<portlist> - Specify a range of ports to be configured.
all - Specify all ports to be configured.
gvrp_state - See below:
enable - Enable GVRP for the ports specified in the port list.
disable - Disable GVRP for the ports specified in the port list.
ingress_checking - See Below:
enable - Enable ingress checking for the specified portlist.
disable - Disable ingress checking for the specified portlist.
acceptable_frame - Specify the type of frame that will be accepted by the port.
tagged_only - Only tagged frame will be received.
admit_all - Both tagged and untagged frames will be accepted.
pvid – Specifies the pvid of the port to be modified, the value range is from 1to 4094.
Only Administrator and Operator-level users can issue this command.
Used to enable the Generic VLAN Registration Protocol (GVRP).
enable gvrp
This command, along with disable gvrp below, is used to enable and disable GVRP
on the Switch, without changing the GVRP configuration on the Switch.
None.
Only Administrator and Operator-level users can issue this command.
Page | 304