Connectivity Fault Management Commands - D-Link DGS-3700 Series Reference Manual

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
C
ONNECTIVITY
Back to Section Header
The Connectivity Fault Management commands in the Command Line Interface (CLI) are listed (along with
the appropriate parameters) in the following table.
C
OMMAND
create cfm md
config cfm md
create cfm ma
config cfm ma
create cfm mep
config cfm mep
delete cfm mep
delete cfm ma
delete cfm md
enable cfm
disable cfm
config cfm ports
show cfm ports
show cfm
show cfm remote_mep
show cfm fault
show cfm port
show cfm mipccm
show cfm pkt_cnt
clear cfm pkt_cnt
cfm loopback
cfm linktrace
show cfm linktrace
delete cfm linktrace
F M
AULT ANAGEMENT
P
ARAMETERS
<string 22> level <int 0-7>
<string 22> {mip [none | auto | explicit] | sender_id [none | chassis | manage |
chassis_manage]}
<string 22> md <string 22>
<string 22> md <string 22> {vlanid <vlanid 1-4094> | mip [none | auto | explicit
| defer] | sender_id [none | chassis | manage | chassis_manage | defer] |
ccm_interval [10ms | 100ms | 1sec | 10sec | 1min | 10min] | mepid_list [add |
delete] <mepid_list>}
<string 32> mepid <int 1-8191> md <string 22> ma <string 22> direction
[inward | outward] port <port>
[mepname <string 32> | mepid <int 1-8191> md <string 22> ma <string 22>]
{state [enable | disable] | ccm [enable | disable] | pdu_priority <int 0-7> |
fault_alarm [all | mac_status | remote_ccm | error_ccm | xcon_ccm | none] |
alarm_time <centisecond 250 -1000> | alarm_reset_time <centisecond 250-
1000>}
[mepname <string 32> | mepid <int 1-8191> md <string 22> ma <string 22>]
<string 22> md <string 22>
<string 22>
<portlist> state [enable | disable]
<portlist>
{[md <string 22> {ma <string 22> {mepid <int 1-8191>}} | mepname <string
32>]}
[mepname <string 32> | md <string 22> ma <string 22> mepid <int 1-8191>]
remote_mepid <int 1-8191>
{md <string 22> {ma <string 22>}}
<port> {level <int 0-7> | direction [inward | outward] | vlanid <vlanid 1-4094>}
{[ports <portlist>{rx | tx}] | rx | tx | ccm}
{[ports <portlist>{rx | tx}] | rx | tx | ccm}
<macaddr> [mepname <string 32> | mepid <int 1-8191> md <string 22> ma
<string 22>] {num <int 1-65535> | [length <int 0-1500> | pattern <string
1500>] | pdu_priority <int 0-7>}
<macaddr> [mepname <string 32> | mepid <int 1-8191> md <string 22> ma
<string 22>] {ttl <int 2-255> | pdu_priority <int 0-7>}
[mepname <string 32> | mepid <int 1-8191> md <string 22> ma <string 22>]
{trans_id <uint>}
{[md <string 22> {ma <string 22> {mepid <int 1-8191>}} | mepname <string
32>]}
Page | 517
C
OMMANDS