Chapter 62 Mld Snooping Multicast (Msm) Vlan Commands - D-Link DGS-3620-52P Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Chapter 62
create mld_snooping multicast_vlan <vlan_name 32> <vlanid 2-4094> {remap_priority [<value
0-7> | none] {replace_priority}}
config mld_snooping multicast_vlan <vlan_name 32> {[add | delete] [member_port <portlist> |
[source_port <portlist> | untag_source_port <portlist>] | tag_member_port <portlist>] | state
[enable | disable] | replace_source_ipv6 <ipv6addr> | remap_priority [<value 0-7> | none]
{replace_priority}} (1)
create mld_snooping multicast_vlan_group_profile <profile_name 1-32>
config mld_snooping multicast_vlan_group_profile <profile_name 1-32> [add | delete]
<mcastv6_address_list>
delete mld_snooping multicast_vlan_group_profile [profile_name <profile_name 1-32> | all]
show mld_snooping multicast_vlan_group_profile {<profile_name 1-32>}
config mld_snooping multicast_vlan_group <vlan_name 32> [add | delete] profile_name
<profile_name 1-32>
show mld_snooping multicast_vlan_group {<vlan_name 32>}
delete mld_snooping multicast_vlan <vlan_name 32>
enable mld_snooping multicast_vlan
disable mld_snooping multicast_vlan
show mld_snooping multicast_vlan {<vlan_name 32>}
config mld_snooping multicast_vlan forward_unmatched [disable | enable]
62-1 create mld_snooping multicast_vlan
Description
This command is used to create an MLD snooping multicast VLAN and implements relevant
parameters as specified. More than one multicast VLAN can be configured. Newly created MLD
snooping multicast VLANs must use a unique VLAN ID and name, i.e. they cannot use the VLAN
ID or name of any existing 802.1q VLAN. Also keep in mind the following conditions: multicast
VLANs cannot be configured or displayed using 802.1Q VLAN commands and the multicast VLAN
snooping function co-exists with the 802.1q VLAN snooping function.
Format
create mld_snooping multicast_vlan <vlan_name 32> <vlanid 2-4094> {remap_priority
[<value 0-7> | none] {replace_priority}}
Parameters
<vlan_name 32> - Specify the name of the multicast VLAN to be created. Each multicast VLAN
is given a name that can be up to 32 characters.
<vlanid 2-4094> - Specify the VLAN ID of the multicast VLAN to be created. The range is from 2
to 4094.
remap_priority - (Optional) Specify the remap priority here.
<value 0-7> - Specify the remap priority (0 to 7) to be associated with the data traffic to be
MLD Snooping
Multicast (MSM) VLAN
Commands
686