D-Link DGS-3700 Series Reference Manual page 76

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
DGS-3700-12:5#config sim_group add 2
Command: config sim_group add 2
Please wait for ACK!!!
SIM Config Success !!!
Success.
DGS-3700-12:5#
To delete a member:
DGS-3700-12:5# config sim_group delete 1
Command: config sim_group delete 1
Please wait for ACK!!!
SIM Config Success!!!
DGS-3700-12:5#
config sim
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To change the time interval of the discovery protocol:
Used to configure role parameters for the SIM protocol on the Switch.
config sim [[commander { group_name <groupname 64>}|candidate]|
dp_interval <sec 30-90> | hold_time <sec 100-255>]
This command is used to configure parameters of switches of the SIM.
commander – Use this parameter to configure the commander switch (CS) for the
following parameters:
group_name <groupname 64> − Used to update the name of the group. Enter an
alphanumeric string of up to 64 characters to rename the SIM group.
dp_interval <30-90> – The user may set the discovery protocol interval, in seconds
that the Switch will send out discovery packets. Returning information to the CS
will include information about other switches connected to it. (Ex. MS, CaS). The
user may set the dp_interval from 30 to 90 seconds.
hold time <sec 100-300> – Using this parameter, the user may set the time, in
seconds, the CS will hold information sent to it from other switches, utilizing the
discovery interval protocol. The user may set the hold time from 100 to 300
seconds.
candidate – Used to change the role of a CS (commander) to a CaS (candidate).
dp_interval <30-90> – The user may set the discovery protocol interval, in seconds
that the Switch will send out discovery packets. Returning information to the CS
will include information about other switches connected to it. (Ex. MS, CaS). The
user may set the dp_interval from 30 to 90 seconds.
hold time <100-255> – Using this parameter, the user may set the time, in seconds,
the Switch will hold information sent to it from other switches, utilizing the
discovery interval protocol. The user may set the hold time from 100 to 255
seconds.
Only Administrator and Operator-level users can issue this command.
Page | 76