D-Link DGS-3700 Series Reference Manual page 279

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
DGS-3700-12:5# clear port_security_entry ports 6
Command: clear port_security_entry ports 6
Success.
DGS-3700-12:5#
show port_security
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the port security configuration:
DGS-3700-12:5#show port_security ports 1-5
Command: show port_security ports 1-5
Port Configuration:
Port State
----- --------
1 Disabled
2 Disabled
3 Disabled
4 Disabled
5 Disabled
DGS-3700-12:5#
enable port_security trap_log
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the port security trap/log setting:
Used to display the current port security configuration.
show port_security_entry {ports [<portlist> | all ] { [ vlan <vlan_name> | vlanid
<vidlist>] }}
This command is used to display port security information of the Switch's ports. The
information displayed includes port security, admin state, maximum number of
learning address and lock mode.
<portlist> − Specifies a port or range of ports to be viewed.
vlan – The port security entries learned on the specified VLANs will be cleared.
vlanid – Specifies a list of VLANs by their VLAN ID.
None.
Lock Address Mode
-----------------
DeleteOnReset
DeleteOnReset
DeleteOnReset
DeleteOnReset
DeleteOnReset
Used to enable the trap/log for port security.
enable port_security trap_log
This command is used to enable port security traps/logs. When this command is
enabled, if there's a new MAC that violates the pre-defined port security
configuration, a trap will be sent out with the MAC and port informationt and the
relevant information will be logged.
None.
Only Administrator and Operator-level users can issue this command.
Max. Learning Addr.
-------------------
1
1
1
1
1
Page | 279