D-Link DGS-3700 Series Reference Manual page 168

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
config time_zone
Restrictions
Example usage:
To configure time zone settings:
DGS-3700-12:5#config time_zone operator + hour 2 min 30
Command: config time_zone operator + hour 2 min 30
Success.
DGS-3700-12:5#
config dst
Purpose
Syntax
Description
Only Administrator and Operator-level users can issue this command.
Used to enable and configure time adjustments to allow for the use of Daylight
Savings Time (DST).
config dst [disable | repeating {s_week <start_week 1-4,last> | s_day <start_day
sun-sat> | s_mth <start_mth 1-12> | s_time start_time hh:mm> | e_week
<end_week 1-4,last> | e_day <end_day sun-sat> | e_mth <end_mth 1-12> |
e_time <end_time hh:mm> | offset [30 | 60 | 90 | 120]} | annual {s_date
start_date 1-31> | s_mth <start_mth 1-12> | s_time <start_time hh:mm> |
e_date <end_date 1-31> | e_mth <end_mth 1-12> | e_time <end_time hh:mm>
| offset [30 | 60 | 90 | 120]}]
This command is used to enable and configure DST. When enabled this will adjust the
system clock to comply with any DST requirement. DST adjustment effects system
time for both manually configured time and time set using SNTP service.
disable − Disable the DST seasonal time adjustment for the Switch.
repeating − Using repeating mode will enable DST seasonal time adjustment.
Repeating mode requires that the DST beginning and ending date be specified
using a formula. For example, specify to begin DST on Saturday during the second
week of April and end DST on Sunday during the last week of October.
annual − Using annual mode will enable DST seasonal time adjustment. Annual mode
requires that the DST beginning and ending date be specified concisely. For
example, specify to begin DST on April 3 and end DST on October 14.
s_week − Configure the week of the month in which DST begins.
<start_week 1-4,last> − The number of the week during the month in which DST
begins where 1 is the first week, 2 is the second week and so on, last is the last
week of the month.
e_week − Configure the week of the month in which DST ends.
Page | 168