D-Link DGS-3700 Series Reference Manual page 233

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
DGS-3700-12:5#disable mac_notification
Command: disable mac_notification
Success.
DGS-3700-12:5#
config mac_notification
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the Switch's MAC address table notification global settings:
DGS-3700-12:5#config mac_notification interval 1 historysize 500
Command: config mac_notification interval 1 historysize 500
Success.
DGS-3700-12:5#
config mac_notification ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable port 7 for MAC address table notification:
DGS-3700-12:5#config mac_notification ports 7 enable
Command: config mac_notification ports 7 enable
Success.
DGS-3700-12:5#
show mac_notification
Purpose
Used to configure MAC address notification.
config mac_notification {interval <int 1-2147483647> | historysize <int 1-500>}
This command is used to monitor MAC addresses learned and entered into the FDB.
interval <sec 1-2147483647> − The time in seconds between notifications. The user
may choose an interval between 1 and 2,147,483,647 seconds.
historysize <1-500> − The maximum number of entries listed in the history log used
for notification.
Only Administrator and Operator-level users can issue this command.
Used to configure MAC address notification status settings.
config mac_notification ports [<portlist> | all] [enable | disable]
This command is used to monitor MAC addresses learned and entered into the FDB.
<portlist> − Specify a port or range of ports to be configured.
all – Entering this command will set all ports on the system.
[enable | disable] – These commands will enable or disable MAC address table
notification on the Switch.
Only Administrator and Operator-level users can issue this command.
Used to display the Switch's MAC address table notification global settings.
Page | 233