D-Link DGS-3700 Series Reference Manual page 311

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
enable pvid auto_assign
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the auto-assign PVID:
DGS-3700-12:5#enable pvid auto_assign
Command: enable pvid auto_assign
Success.
DGS-3700-12:5#
show pvid auto_assign
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display PVID auto-assignment state:
DGS-3700-12:5#show pvid auto_assign
Command: show pvid auto_assign
PVID Auto-assignment: Enabled
DGS-3700-12:5#
config gvrp
Purpose
Syntax
Description
Enable/disable auto assignment of pvid.
enable|disable pvid auto_assign
The command enables the auto-assign of PVID.
If "auto-assign PVID" is disabled, PVID only be changed by PVID configuration
(user changes explicitly). The VLAN configuration will not automatically change
PVID.
If "Auto-assign PVID" is enabled, PVID will be possibly changed by PVID or VLAN
configuration. When user configures a port to VLAN X's untagged membership,
this port's PVID will be updated with VLAN X. In the form of VLAN list
command, PVID is updated with last item of VLAN list. When user removes a port
from the untagged membership of the PVID's VLAN, the port's PVID will be
assigned with "default VLAN".
The default setting is enabled.
None.
Only Administrator and Operator-level users can issue this command.
Show PVID auto-assigment state.
show pvid auto_assign
This command is used to display PVID auto-assignment state.
None.
None.
Used to configure the timer's value of GVRP and MAC address of GVRP's PDU of
NNI port in Q-in-Q mode.
config gvrp [timer [join | leave | leaveall] < value 100-100000> | nni_bpdu_addr
[dot1d | dot1ad]]
This command is used to set the GVRP timer's value and GVRP's PDU MAC address
of NNI port in Q-in-Q mode. The default value for Join time is 200 milliseconds;
Page | 311