D-Link DGS-3700 Series Reference Manual page 445

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
config mac_based_access_control ports
Restrictions
Example usage
To config mac_based_access_control port state:
DGS-3700-12:5#config mac_based_access_control ports 1-8 state enable
Command: config mac_based_access_control ports 1-8 state enable
Success.
DGS-3700-12:5#
config mac_based_access_control guest_vlan ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage
To config mac_based_access_control port guest_vlan:
DGS-3700-12G:5#config mac_based_access_control guest_vlan ports 1
Command: config mac_based_access_control guest_vlan ports 1
Success.
DGS-3700-12G:5#
create mac_based_access_control guest_vlan
Purpose
Syntax
Description
the option host_based for ports that are in guest VLAN mode.
aging_time - A time period during which an authenticated host will be kept in the
authenticated state. When the aging time is timed-out, the host will be moved back
to unauthenticated state.
infinite - Specifies an unlimited aging time.
<min 1-440> - Specify the age-out time, in minutes, between 1 and 440.
block_time - Specifies the blocking time, in seconds, between 1 and 300.
max_users - Specifies the number of maximum users.
<value 1-1000> - Specify the maximum number of users between 1 and 1000.
no_limit - Specifies an unlimited number of users.
Only Administrator and Operator-level users can issue this command.
Used to configure the mac_based_access_control guest_vlan membership
config mac_based_access_control guest_vlan ports <portlist>
This command puts the specified port in guest-vlan mode. For those ports not
contained in the portlist, they are in non-guest VLAN mode.For detailed
information for operation of guest VLAN mode, please see the description for
configuring mac based_access_control port command.
<portlist> – When the guest VLAN is configured for a port, the guest VLAN will be
enabled, only after MAC_based_access_control and global are both enabled on the
same port. This port will be added to the guest VLAN as an untagged member and
can access this guest VLAN before being authenticated.
Only Administrator and Operator-level users can issue this command.
Used to assign the guest VLAN.
create mac_based_access_control [guest_vlan <vlan_name 32> | guest_vlanid
<vlanid 1-4094>]
This command is used to assign the guest VLAN.
Page | 445