D-Link DGS-3700 Series Reference Manual page 331

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
enable autoconfig
Restrictions
Example usage:
To enable autoconfiguration on the Switch:
DGS-3700-12:5#enable autoconfig
Command: enable autoconfig
Success.
DGS-3700-12:5#
NOTE: More detailed information for this command and related commands can be found
in the section titled Switch Utility Commands.
disable autoconfig
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable the auto configuration function:
DGS-3700-12:5#disable autoconfig
Command:disable autoconfig
Success.
DGS-3700-12:5#
show autoconfig
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
When autoconfig is enabled, the Switch becomes a DHCP client automatically (same
as: config ipif System dhcp). The DHCP server must have the TFTP server IP
address and configuration file name, and be configured to deliver this information
in the data field of the DHCP reply packet. The TFTP server must be running and
have the requested configuration file in its base directory when the request is
received from the Switch. Consult the DHCP server and TFTP server software
instructions for information on loading a boot file or configuration file.
Only Administrator and Operator-level users can issue this command.
This command is used to automatically disable getting the configuration from the
TFTP server.
disable autoconfig
When auto configuration is disabled, the switch will configure itself using the local
configuration file.
None.
Only Administrator and Operator-level users can issue this command.
Show the status of automatically getting the configuration from the TFTP server.
show autoconfig
The command is used to show autoconfig enable or disable status.
None.
Only Administrator and Operator-level users can issue this command.
Page | 331