D-Link DGS-3700 Series Reference Manual page 536

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
config ethernet_oam ports mode
Parameters
Restrictions
Example usage:
To configure port 1 to OAM mode to passive:
DGS-3700-12:5#config ethernet_oam ports 1 mode passive
Command: config ethernet_oam ports 1 mode passive
Success.
DGS-3700-12:5#
config ethernet_oam ports state
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable Ethernet OAM on port 1:
DGS-3700-12:5#config ethernet_oam ports 1 state enable
Command: config ethernet_oam ports 1 state enable
Success.
DGS-3700-12:5#
config ethernet_oam ports link_monitor error_symbol
Purpose
Syntax
Description
disallowed by ports in passive mode.
Initiate OAM discovery and Start or stop remote loop-back.
Note: When a port is OAM-enabled, changing the OAM mode will cause the OAM
discovery to be re-started.
portlist – Specifies a range of ports to be configured. Use all to specify all ports.
mode – Specifies to operate in either active mode or passive mode. The default mode
is active.
Only Administrator and Operator-level users can issue this command.
Used to enable or disable Ethernet OAM.
config ethernet_oam ports [<portlist> | all] state [enable | disable]
This command used to enable or disable the port's Ethernet OAM function. Enabling
a port's OAM will cause the port to start OAM discovery. If a port is active, it
initiates the discovery otherwise it reacts only to the discovery received from its
peer.
Disabling a port's OAM will cause the port to send out a dying gasp event to the peer
and then disconnect the established OAM link.
portlist – Specifies a range of ports to be configured. Use all to specify all ports.
state – Specifies to enable or disable the OAM function. The default state is disable.
Only Administrator and Operator-level users can issue this command.
Used to configure Ethernet OAM link monitoring error symbols.
config ethernet_oam ports [<portlist> | all ] link_monitor
error_symbol{ threshold < range 0 - 4294967295> | window < millisecond
1000-60000> | notify_state [enable | disable]}
This command is used to configure ports Ethernet OAM link monitoring error
symbols. The link monitoring function provides a mechanism to detect and indicate
link faults under a variety of conditions. OAM monitors the statistics on the
Page | 536