D-Link DGS-3700 Series Reference Manual page 382

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
config flow_meter
Restrictions
Example usage:
burst_size - Specify the burst size for the single rate two color mode. The unit is
Kbytes.
rate_exceed - Specify the action for packets that exceed the committed rate in single
rate two color mode. The action can be specified as one of the following:
drop_packet - Drop the packet immediately.
remark_dscp - Mark the packet with a specified DSCP.
tr_tcm − Specify the "two rate three color mode"
cir <value 0-1000000> − Specify the "committed information rate"
The unit is Kbps.
cbs <value 0-16384> − Specify the "committed burst size"
1. The unit is Kbyte. That is to say, 1 means 1Kbyte.
2. This parameter is an optional parameter. The default value is 4.
3. The max set value is 16*1024.
pir <value 0-1000000> − Specify the "peak information rate"
The unit is Kbps.
pbs <value 0-16384> − Specify the "peak burst size"
1. The unit is Kbyte. That is to say, 1 means 1Kbyte.
2. This parameter is an optional parameter.The default value is 4
3. The max set value is 16*1024.
sr_tcm − Specify the "single rate three color mode"
cir <value 0-1000000> − Specify the "committed information rate"
The unit is Kbps.
cbs <value 0-16384> − Specify the "committed burst size"
1. The unit is Kbyte. That is to say, 1 means 1Kbyte.
2. The max set value is 16*1024.
ebs <value 0-16384> − Specify the "excess burst size"
1. The unit is Kbyte. That is to say, 1 means 1 Kbyte.
2. The max set value is 16*1024.
conform - Specify the action when packet is in "green color"
permit - Permit the packet.
replace_dscp - Change the dscp of the packet.
counter - Specify the counter. This is optional. The default is "disable".
exceed - Specify the action when packet is in "yellow color"
permit - Permit the packet.
replace_dscp - Change the dscp of packet
counter - Specify the counter. This is optional. The default is "disable".
drop – Drop the packet.
violate - Specify the action when packet is in "red color"
permit - Permit the packet.
replace_dscp - Change the dscp of packet.
drop – Specifies to drop the packet.
counter - Specify the counter. This is optional. The default is "disable".
The resource may be limited so that the counter can not be turned on. The limitation is
project dependent. The counter will be cleared when the function is disabled.
delete − Delete the specified flow_meter.
Only Administrator and Operator-level users can issue this command.
Page | 382