D-Link DGS-3700 Series Reference Manual page 332

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
To display the auto configuration status:
DGS-3700-12:5#show autoconfig
Command: show autoconfig
Autoconfig State: Disabled
DGS-3700-12:5#
enable ipif_ipv6_link_local_auto
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the automatic configuration of link local address for an interface:
DGS-3700-12:5#enable ipif_ipv6_link_local_auto all
Command: enable ipif_ipv6_link_local_auto all
Success.
DGS-3700-12:5#
disable ipif_ipv6_link_local_auto
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable the automatic configuration of link local address for an interface:
DGS-3700-12:5#disable ipif_ipv6_link_local_auto System
Command: disable ipif_ipv6_link_local_auto System
Success.
DGS-3700-12:5#
Used to enable IPv6 link local auto configure on IP interfaces.
enable ipif_ipv6_link_local_auto [<ipif_name 12> | all ]
This command is used to enable the auto configuration of link local addresses when
there are no IPv6 addresses explicitly configured. When an IPv6 address is
explicitly configured, the link local address will be automatically configured, and
the IPv6 processing will be started. When there is no IPv6 address explicitly
configured, by default, link local address is not configured and the IPv6 processing
will be disabled. By enabling this automatic configuration, the link local address
will be automatically configured and IPv6 processing will be started.
<ipif_name 12> − The name of the IP interface.
all – Indidcates all IP interfaces.
Only Administrator and Operator-level users can issue this command.
Used to disable IPv6 link local auto configure on IP interfaces.
disable ipif_ipv6_link_local_auto [<ipif_name 12> | all ]
This command is used to disable the auto configuration of link local addresses when
no IPv6 address is explicitly configured.
<ipif_name 12> − The name of the IP interface.
all – Indicates all IP interfaces.
Only Administrator and Operator-level users can issue this command.
Page | 332