D-Link DGS-3700 Series Reference Manual page 325

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
DGS-3700-12:5#config arp_aging time 30
Command: config arp_aging time 30
Success.
DGS-3700-12:5#
show arpentry
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the ARP table:
DGS-3700-12:5#show arpentry
Command: show arpentry
ARP Aging Time : 20
Interface IP Address
------------- ---------------
System 10.0.0.0
System 10.24.73.21
System 10.48.74.121
System 10.255.255.255
Total Entries: 4
DGS-3700-12:5#
clear arptable
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To remove dynamic entries in the ARP table:
Used to display the ARP table.
show arpentry {ipif <ipif_name 12> | ipaddress <ipaddr> | static | mac_address
<macaddr>}
This command is used to display the current contents of the Switch's ARP table.
ipif <ipif_name 12> − The name of the IP interface the end node or station for which
the ARP table entry was made, resides on.
ipaddress <ipaddr> − The network address corresponding to the IP interface name
above.
static – Displays the static entries to the ARP table.
<macaddr> - Displays the ARP entry by MAC address.
If no parameter is specified, all current effective ARP entries will be displayed.
None.
MAC Address
-----------------
FF-FF-FF-FF-FF-FF
00-01-02-03-04-00
00-50-BA-00-07-36
FF-FF-FF-FF-FF-FF
Used to remove all dynamic ARP table entries.
clear arptable
This command is used to remove dynamic ARP table entries from the Switch's ARP
table. Static ARP table entries are not affected.
None.
Only Administrator and Operator-level users can issue this command.
Type
---------------
Local/Broadcast
Local
Static
Local/Broadcast
Page | 325