D-Link DGS-3700 Series Reference Manual page 121

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
Description
Parameters
Restrictions
Example usage:
To configure a Syslog host:
DGS-3700-12:5#config syslog host 1 severity debug
Command: config syslog host 1 severity debug
Success.
DGS-3700-12:5#
Example usage:
To configure a syslog host for all hosts:
The config syslog command configures the syslog host configurations. The user can
choose and report a specific level of messages to a specific host. When the user
chooses a specific level for a specific host, messages which are at that severity
level or higher will be reported to the specified host.
host - The host index or all hosts.
severity - See below:
emergency Severity level 0
alert Severity level 1
critical Severity level 2
error Severity level 3
warning
notice Severity level 5
informational Severity level 6
debug Severity level 7
facility - Some of the operating system daemons and processes have been assigned
Facility values. Processes and daemons that have not been explicitly assigned a
Facility may use any of the "local use" facilities or they may use the "user-level"
Facility. Those Facilities that have been designated are shown below. This facility
setting will be put in the syslog packet when it is sent to a specific syslog server.
local0 user-defined Facility
local1 user-defined Facility
local2 user-defined Facility
local3 user-defined Facility
local4 user-defined Facility
local5 user-defined Facility
local6 user-defined Facility
local7 user-defined Facility
udp_port - The UDP port number.
ipaddr - Specify IP address for the host.
ipv6addr - Specify IPv6 address for the host.
state - The syslog protocol is used for the transmission of event notification messages
across networks to a host. The option enables or disables the host to receive such
messages.
Only Administrator and Operator-level users can issue this command.
Severity level 4
Page | 121