Cfm Extension (Itu-T Y.1731) - D-Link DGS-3700 Series Reference Manual

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
O A
BJECT CCESS
Table of Contents
Next Section
Previous Section

CFM EXTENSION (ITU-T Y.1731)

Back to Section Header
The CFM Extension commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
C
OMMAND
config cfm ais
config cfm lock
cfm lock
cfm loopback
show cfm
show cfm fault
Each command is listed, in detail, in the following sections.
config cfm ais
Purpose
Syntax
Description
Parameters
M
ETHOD
P
ARAMETERS
md <string 22> ma <string 22> mepid <int 1-8191> { period [ 1sec |
1min] | level <int 0-7> | state [ enable | disable] }(1)
md <string 22> ma <string 22> mepid <int 1-8191> { period [1sec |
1min] | level <int 0-7>| state [enable | disable]}(1)
md <string 22> ma <string 22> mepid <int 1-8191> remote_mepid <int
1-8191> action [start | stop]
<macaddr> [mepname <string 32> | mepid <int 1-8191> md <string 22>
ma <string 22>] {num <int 1-65535> | [length <int 0-1500> | pattern
<string 1500>] | pdu_priority <int 0-7>}
{ [ md <string 22> {ma <string 22> {mepid <int 1-8191>}} | mepname
<string 32>]}
{md <string 22> {ma <string 22>}}
Used to configure parameters of AIS function.
config cfm ais md <string 22> ma <string 22> mepid <int 1-8191> { period [ 1sec
| 1min] | level <int 0-7> | state [ enable | disable] }(1)
This command is used to configure the parameters of AIS function on a MEP.
The default state is disabled.
The default period is 1 second.
The default client MD level is MD level at which the most immediate client layer
MIPs and MEPs exist.
Note: This default client MD level is not a fixed value. It may change when creating
or deleting higher level MD and MA on the device.
When the most immediate client layer MIPs and MEPs do not exist, the default client
MD level cannot be calculated. If the default client MD level cannot be calculated
and user doesn't designate a client level, the AIS and LCK PDU cannot be
transmitted.
md –Maintenance domain name.
ma –Maintenance Association name.
mepid –The MEP ID in the MD which sends AIS frame.
state – Specifies the MEP AIS state
enable - AIS function enabled.
(OAM) S
Page | 511
ECTION
11