D-Link DGS-3700 Series Reference Manual page 229

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
DGS-3700-12:5#show mcast_filter_profile ipv4
Command: show mcast_filter_profile ipv4
Profile ID Name
---- ----------
1
Total Profile Count : 1
DGS-3700-12:5#
config limited_multicast_addr ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To config port 1,3 to set the multicast address profile 2:
DGS-3700-12:5#config limited_multicast_addr ports 1,3 ipv4 add profile_id 2
Command: config limited_multicast_addr ports 1,3 ipv4 add profile_id 2
Success.
DGS-3700-12:5#
show limited_multicast_addr
Purpose
Syntax
Description
Multicast Addresses
---------------------------
RG 234.1.1.1 - 238.244.244.244
Used to configure the multicast address filtering function on a port.
config limited_multicast_addr [ports <portlist> | vlanid <vlanid_list>]
{[ipv4|ipv6]} {[add | delete] [profile_id <value 1-60> | profile_name <name 1-
32> ] | access [permit | deny]}
This command is used to configure the multicast address filtering function on a port.
When there are no profiles specified with a port, the limited function is not
effective.
When the function is configured on a port, it limits the multicast group operated by
the IGMP.
<portlist> − A range of ports to config the multicast address filtering function.
<vlanid_list> – A range of VLAN IDs to config the multicast address filtering
function.
add − Add a multicast address profile to a port.
delete − Delete a multicast address profile to a port.
profile_id − A profile to be added to or deleted from the port.
profile_name <name 1-32> − The name of the profile.
permit − Specifies that the packet that match the addresses defined in the profiles will
be permitted. The default mode is permit.
deny − Specifies that the packet that match the addresses defined in the profiles will
be denied.
Only Administrator and Operator-level users can issue this command.
Used to show per-port Limited IP multicast address range.
show limited_multicast_addr [ports <portlist> | vlanid <vlanid_list>] {[ipv4 |
ipv6]}
This command allows you to show multicast address range by ports.
When the function is configured on a port, it limits the multicast groups operated by
the IGMP or MLD snooping function and layer 3 function.
Page | 229