D-Link DGS-3700 Series Reference Manual page 93

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
config lldp
Parameters
Restrictions
Example usage:
To change the packet transmission interval:
DGS-3700-12:5#config lldp message_tx_interval 30
Command: config lldp message_tx_interval 30
Success.
DGS-3700-12:5#
To change the multiplier value:
DGS-3700-12:5#config lldp message_tx_hold_multiplier 3
Command: config lldp message_tx_hold_multiplier 3
Success.
DGS-3700-12:5#
To configure the delay-interval interval:
DGS-3700-12:5#config lldp tx_delay 8
Command: config lldp tx_delay 8
Success.
DGS-3700-12:5#
To change the re-initialization delay interval to five seconds:
switch's MIB. The TX delay is used to change the minimum time (delay-interval)
any LLDP port will delay advertising successive LLDP advertisements due to a
change in LLDP MIB content. The TX delay defines the minimum interval
between sending of LLDP messages due to constany change of MIB content. A re-
enabled LLDP port will wait for the reinit delay after the last disable command
before reinitializing.
message_tx_interval - Specify the interval between consecutive transmissions of
LLDP advertisements on any given port. The range is from 5 to 32768 seconds.
The default setting is 30 seconds.
message_tx_hold_multiplier - Specify the range is from 2 to 10. The default setting is
4.
tx_delay - Specify the range is from 1 to 8192 seconds. The default setting is 2
seconds.
Note: tx_delay should be less than or equal to 0.25 * msgTxInterval.
reint_delay - Specify the range is from 1 to 10 seconds. The default setting is 2
seconds.
Only Administrator and Operator-level users can issue this command.
Page | 93