D-Link DGS-3700 Series Reference Manual page 417

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
config authen server_host
Restrictions
Example usage:
To configure a TACACS+ authentication server host, with port number 4321, a timeout value of 12
seconds and a retransmit count of 4.
DGS-3700-12:5#config authen server_host 10.1.1.121 protocol tacacs+ port 4321 timeout
12 retransmit 4
Command: config authen server_host 10.1.1.121 protocol tacacs+ port 4321 timeout 12
retransmit 4
Success.
DGS-3700-12:5#
delete authen server_host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete a user-defined TACACS+ authentication server host:
DGS-3700-12:5#delete authen server_host 10.1.1.121 protocol tacacs+
Command: delete authen server_host 10.1.1.121 protocol tacacs+
Success.
DGS-3700-12:5#
port <int 1-65535> − Enter a number between 1 and 65535 to define the virtual port
number of the authentication protocol on a server host. The default port number is
49 for TACACS/XTACACS/TACACS+ servers and 1812 and 1813 for RADIUS
servers but the user may set a unique port number for higher security.
key <key_string 254> − Authentication key to be shared with a configured TACACS+
or RADIUS server only. Specify an alphanumeric string up to 254 characters or
choose none.
timeout <int 1-255> − Enter the time in seconds the Switch will wait for the server
host to reply to an authentication request. The default value is 5 seconds.
retransmit <int 1-20> − Enter the value in the retransmit field to change how many
times the device will resend an authentication request when the server does not
respond. This field is inoperable for the TACACS+ protocol.
Only Administrator-level users can issue this command.
Used to delete a user-defined authentication server host.
delete authen server_host <ipaddr> protocol [tacacs | xtacacs | tacacs+ | radius]
This command is used to delete a user-defined authentication server host previously
created on the Switch.
server_host <ipaddr> − The IP address of the remote server host to be deleted.
protocol – The protocol used by the server host the user wishes to delete. The user
may choose one of the following:
tacacs – Enter this parameter if the server host utilizes the TACACS protocol.
xtacacs − Enter this parameter if the server host utilizes the XTACACS protocol.
tacacs+ − Enter this parameter if the server host utilizes the TACACS+ protocol.
radius − Enter this parameter if the server host utilizes the RADIUS protocol.
Only Administrator-level users can issue this command.
Page | 417