D-Link DGS-3700 Series Reference Manual page 419

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
DGS-3700-12:5#create authen server_group group_1
Command: create authen server_group group_1
Success.
DGS-3700-12:5#
config authen server_group
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To add an authentication host to server group "group_1":
Used to configure a user-defined authentication server group.
config authen server_group [tacacs | xtacacs | tacacs+ | radius | <string 15>] [add
| delete] server_host <ipaddr> protocol [tacacs | xtacacs | tacacs+ | radius]
This command will configure an authentication server group. A server group is a
technique used to group TACACS/XTACACS/TACACS+/RADIUS server hosts
into user defined categories for authentication using method lists. The user may
define the type of server group by protocol or by previously defined server group.
Up to eight authentication server hosts may be added to any particular group
server_group − The user may define the group by protocol groups built into the
Switch (TACACS/XTACACS/TACACS+/RADIUS), or by a user-defined group
previously created using the create authen server_group command.
tacacs – Use this parameter to utilize the built-in TACACS server protocol on the
Switch. Only server hosts utilizing the TACACS protocol may be added to this
group.
xtacacs – Use this parameter to utilize the built-in XTACACS server protocol on the
Switch. Only server hosts utilizing the XTACACS protocol may be added to this
group.
tacacs+ – Use this parameter to utilize the built-in TACACS+ server protocol on the
Switch. Only server hosts utilizing the TACACS+ protocol may be added to this
group.
radius – Use this parameter to utilize the built-in RADIUS server protocol on the
Switch. Only server hosts utilizing the RADIUS protocol may be added to this
group.
<string 15> − Enter an alphanumeric string of up to 15 characters to define the
previously created server group. This group may add any combination of server
hosts to it, regardless of protocol.
add/delete – Enter the correct parameter to add or delete a server host from a server
group.
server_host <ipaddr> − Enter the IP address of the previously configured server host
to add or delete.
protocol – Enter the protocol utilized by the server host. There are three options:
tacacs – Use this parameter to define the protocol if the server host is using the
TACACS authentication protocol.
xtacacs – Use this parameter to define the protocol if the server host is using the
XTACACS authentication protocol.
tacacs+ – Use this parameter to define the protocol if the server host is using the
TACACS+ authentication protocol.
radius – Use this parameter to define the protocol if the server host is using the
RADIUS authentication protocol.
Only Administrator-level users can issue this command.
Page | 419