Remove The Nvme Switch Card Cables; Install The Nvme Switch Card Cables - Oracle netra X5-2 Service Manual

Remove the NVMe Switch Card Cables

2. Review the command output, and verify that the entry for the slot number that
was disabled no longer appears in the output.
Related Information
"Unmount an NVMe Storage Drive (Oracle Linux)" on page 104
■
"Remove an NVMe Storage Drive" on page 106
■
"Verify Removal of an NVMe Storage Drive (Oracle Linux)" on page 107
■
"Power On an NVMe Storage Drive and Attach a Device Driver (Oracle
■
Linux)" on page 112
"Verify the Operation of an NVMe Storage Drive" on page 112
■
Remove the NVMe Switch Card Cables
Caution -
To avoid personal injury or damage to the server, you must disconnect power cords before
servicing the cables.
1. Prepare the server for service.
See "Preparing for Service" on page
2. Disconnect the NVMe cables from the Oracle PCIe NVMe switch card.
Press each latch, and then pull out to disengage the cable from each connector.
3. Disconnect the NVMe cables from the front storage drive backplane.
Press each latch, and then pull out to disengage the cable from each connector.
4. Remove the NVMe cables from the server.
Carefully remove the NVMe cable bundle from the chassis. Be careful not to snag the cables on
the server components.
Related Information
"Install the NVMe Switch Card Cables" on page 108
■
"Remove the NVMe Switch Card" on page 110
■
"Install an NVMe Switch Card" on page 110
■

Install the NVMe Switch Card Cables

Install the NVMe cables between the front storage drive backplane and the
1.
Oracle PCIe NVMe switch card.
108 Netra Server X5-2 Service Manual • October 2016
The system supplies power to the cables even when the server is powered off.
61.