Transfer/Separation Corona Wire Replacement - Ricoh FT5233 Service Manual

12 February 1992
6.15 TRANSFER/SEPARATION CORONA WIRE
REPLACEMENT
[B]
[D]
1. Lower the T & S corona unit and remove it from the copier.
2. Remove the paper guide [A] from the T & S corona unit by lifting the rear
part and sliding it to the rear.
3. Remove the front and rear end block covers [B] (2 hooks each).
NOTE: When removing the end block covers, be careful not to break off
the side hooks.
4. Remove the wire hook cover [C] from the rear end block.
5. Unhook the corona wire tension springs [D] and remove the transfer and
separation corona wires.
NOTE: Be careful not to damage or lose the tension springs.
[A]
[C]
5-67
AROUND THE DRUM
[B]