Ricoh FT5233 Service Manual page 692

INSTALLATION
[B]
[G]
[C]
[A]
13. Set the DF harness [A] as follows:
(1) Fiber optics cable [B] — CN106 (Main control board) [C]
(2) 4P connector (White) [D] — 4P connector (White/copier) [E]
14. Secure the DF harness with a plastic clamp [F] (1 screw) as shown.
15. Secure the protective earth wire [G] (1 grounding screw and 1 toothed
washer).
16. Close and secure the main control board assembly.
NOTE: Place the DF harness in front of the main control board as shown.
17. Reinstall the rear cover [H].
18. Install the angle stopper [I] (2 screws), and the original table [J].
[F]
[E]
[D]
[B]
[A]
24
12 February 1992
[I]
[H]
[J]