Ricoh FT5233 Service Manual page 157

COPIER INSTALLATION
[E]
[A]
26. Close the front door and set the copy tray [A].
NOTE: The following steps from 27 to 30 are required only to install the
optional platen cover [B].
27. Remove the rear cover (remove 2 screws and loosen 2 screws).
28. Install the 2 shoulder screws [C] on the top cover as shown.
29. Pass the harness [D] through the hole of the top cover and install the
optional platen cover (2 screws).
30. Couple the platen cover sensor connector [E] (3P white) with the copier
and reinstall the rear cover.
31. Stick the symbols explanation decal [F] on the top cover as shown. (If the
ARDF will be installed, stick the decal on the corresponding position of
the ARDF.)
32. If local voltage is 230 V or 240 V, perform the voltage change procedure
(following the installation procedure).
[B]
[D]
3-10
12 February 1992
[F]
[C]