Ricoh FT5233 Service Manual page 734

ROLLER DRIVE BELT REPLACEMENT
10. ROLLER DRIVE BELT REPLACEMENT
[J]
[I]
[K]
[L]
1. Remove the front covers [A] (2 screws) and rear cover [B] (2 screws).
2. Lift off the top cover [C].
3. Remove the top stay [D].
NOTE: Be sure that the discharge brush on the top stay is facing the exit
4. Lift the upper paper guide [E] up and out of position.
5. Lift the lower paper guide [F] out of position and turn it over to remove the
roller drive belt [G].
NOTE: Be careful not to damage the sorter home position switch
6. Remove the transfer wheel [I], spacer [J], pin [K] and bushing [L] (1
C-ring).
7. Slide the wheel shaft [M] towards the front and remove the roller drive
belt.
[B]
[G]
side of the sorter when reinstalling it.
actuator [H] when reassembling.
[E]
[F]
[M]
16
12 February 1992
[C]
[D]
[H]
[A]