Ricoh FT5233 Service Manual page 168

12 February 1992
2.5 TRAY HEATER INSTALLATION (OPTION)
[F]
NOTE: The optional tray heaters keep copy paper dry. In humid
environments, copy paper may crease as it comes out of the
fusing unit. The heaters are available as service parts.
Required parts:
The contents of the kits
are as follows:
CAUTION: Unplug the copier power cord before starting the following
procedure.
1. Open the copier front door.
2. Pull out the duplex tray [A] and remove the tray stopper brackets [B], [C]
on both side rails as shown (1 screw each), and then remove the duplex
tray from the copier [duplex machines only].
3. Pull out the paper tray [D] and remove the tray stopper brackets [E], [F]
on both sides as shown (1 screw each) and then remove the paper tray
from the copier [both paper trays for non-duplex machines].
[C]
[E]
[D]
P/N A0699500: Tray Heater Kit –115V
P/N A0699501: Tray Heater Kit –230V
Tray heater
Tray heater bracket
Wire saddle
Philips pan head screw
Decal: High Temp.
3-21
COPIER INSTALLATION
[A]
2 sets
2 sets
1 piece
1 piece
1 piece
3 pieces
1 piece
[B]