Ricoh FT5233 Service Manual page 786

12 February 1992
4.2 INSTALLATION PROCEDURE
[A]
[A]
CAUTION: Unplug the copier power cord before starting the following
procedure.
NOTE: Keep the shipping retainers after installing the machine. They will be
roused if in the future the machine is transported to an another
location.
Proper reinstallation of the shipping retainers is required in order to
avoid any transport damage.
1. Remove the strips of tape [A]. (3 tray type: 4 strips, 1 tray type: 2 strips).
2. Remove the accessory bag [B] (1 tape).
3. Pull out the paper tray and remove a strip of tape and the foam block. Do
this for all the paper trays.
4. Set the copier [C] onto the paper tray unit [D]. Align the 2 pins [E] of the
paper tray unit with the holes in the base plate of the copier. At this time
each side of the copier and paper tray unit will align with one another [F].
[B]
[A]
[F]
[F]
9
INSTALLATION
[C]
[E]
[D]