Ricoh FT5233 Service Manual page 165

COPIER INSTALLATION
[C]
[A]
13. Open the copier front door.
14. While lifting the color development unit lock lever [A], pull out he cover
plate [B].
15. Holding the strap of the color development unit with your left hand, hold
the toner supply unit with your right hand, and insert the development unit
along the guide rails [C].
16. While lifting the color development unit lock lever, push the unit in until it
stops.
17. Stick the decal [D] on the copier front door as shown and close the copier
front door.
18. While pressing both "1" and "3" on the operation panel number keys, turn
on the main switch in order to access the SP mode.
NOTE: Release the number keys after confirming that the call service
19. Enter "10" using the number keys and then press the enter key.
(The copier starts the color developer initialization, this lasts about 1
minute, and the beeper sounds 5 times)
20. Turn the main switch off and on.
21. Check the color copy quality.
[B]
indicator and the copy counter number "0" are blinking.
3-18
12 February 1992
[D]