Ricoh FT5233 Service Manual page 789

INSTALLATION
[E]
[D]
13. Set the wire saddle [A] on the harness bracket [B] and position the paper
tray harness [C] and the tray heater harness [D] in the wire saddle.
14. Install the harness bracket [B] as shown (2 screws).
NOTE: Make sure that the screws are firmly secured so that the
protective earth between the copier and the paper tray unit is
maintained.
15. Couple the connector [E] of the tray heater harness with the copier and
couple the connectors of the paper tray harness with the following
connectors of the copier main control board:
11p connector [F] ...................... CN112
8p connector [G] ...................... CN113
16. Follow the copier installation procedure.
[C]
[A]
[B]
12
[F]
12 February 1992
[G]