Service Program Mode Table - Ricoh FT5233 Service Manual

SERVICE PROGRAM MODE
2.2

SERVICE PROGRAM MODE TABLE

NOTE: 1. A " " after the mode name means that copies can be made.
For these modes, the copier goes automatically into copy
mode when an SP mode number is selected by pressing the
"#" key, or when the data number for adjustment is entered by
pressing the "#" key after selecting the SP mode number.
To make copies, enter desired copy quantity, select ID level
and paper tray, then press the Start key.
If you do not wish to make copies, press the "#" key instead of
the Start key.
2. A "•" before the mode number means that the mode can be
accessed by users and sales representatives.
3. In the Function column, comments (extra information) are in
italics.
4. In the Data column, the default value is printed in bold letters.
Mode No.
2 Free Run Set
3 Free Run Reset
4 Forced Start
5 Lamp OFF
No Misfeed
6
Detection
Call Service
7
Indicator
8 Input Check
9 Output Check
Function
Sets the copier in free run mode.
(The copier runs without paper feeding .
After SP2 is set, press the start key to start
free run operation.
Before pressing the start key you can select
any other SP mode in which copying is
possible [ mark]. ["#"→SPNo.→"#"→Start
key].)
Resets the copier from free run mode.
Copies can be made before being warmed up.
(Copy quality and paper transport are not
assured .)
Copies are made with exposure lamp OFF.
(Black copies are made.)
Copies are made without ON check of jam
detection.
Indicates the cause of a blinking call service
indicator.
(Indicates 0, 1, 2, 3, 12, 13, 23, or 123 in the
three digit indicator.)
Displays the input data from sensors and
switches.
(For data, see page 4 - 28.)
Electrical components turn on.
(For data, see page 4 - 31.)
4-12
12 February 1992
Data
0: Normal
1: PM
2: ID sensor
failure
3: Toner
overflow.