Ricoh FT5233 Service Manual page 826

12 February 1992
13. INSTALLATION PROCEDURE
NOTE: The sorter adapter (A328) should be installed before the sorter
stapler is.
The copier must be placed on the paper tray unit, or a table of
exactly the same height, so that the copier and sorter stapler
paper paths meet.
An interface PCB (A344) is also necessary.
CAUTION: Unplug the copier power cord before starting the following
procedure.
1. Remove the strip of tape [A] on the front door.
2. Open the front door, then remove 5 strips of tape [B] and a styrofoam
block [C]. Raise the staple unit by rotating the staple unit positioning knob
[D] counterclockwise, then remove the sponge cushion [E] underneath.
[D]
[A]
[C]
25
INSTALLATION PROCEDURE
[B]
[E]
[B]