OPTICS
2.2
EXPOSURE LAMP REPLACEMENT
[A]
[B]
NOTE: Do not touch the reflector or the new exposure lamp with your
bare hands. Use a strip of paper as shown aver page. (Oil marks
from fingers on the lamp or reflectors will be affected by heat
from the lamp and will cause discoloration.)
1. Turn off the main switch.
2. Remove the exposure glass. (See Exposure Glass Removal.)
3. Move the first scanner [A] to the cutout position at the front and rear
frames [B]. (See illustration.)
4. Remove the reflector cover [C] (2 screws).
5. Remove the rear terminal bracket [D] (1 screw).
5-8
12 February 1992
[C]
[B]
[D]