REPLACEMENT AND ADJUSTMENT
CAUTION: Do not damage the paper sensor [K] when removing the
exit roller.
[A]
[B]
7. Remove the wheel sensor assembly [A] (1 screw).
8. Remove the rear transfer wheel [B] (1 E-ring).
NOTE: Be sure not to lose the pin [C] for the wheel.
9. Remove the pin and bushing [D].
10. Loosen the four mounting screws [E] of the wheel drive motor [F].
11. Lift the wheel drive motor and slip off the timing belt [G].
12. Slide off the wheel drive shaft [H] and remove the exit roller [I]
and O-ring [J].
13. Replace the exit roller and O-ring, then reassemble.
NOTE: a) When reinstalling the wheel sensor assembly, be sure that the
sensor does not touch the wheel.
b) When remounting the wheel drive motor, adjust the timing belt
tension. (See Timing Belt Tension Adjustment.)
[D]
[H]
[G]
18
12 February 1992
[C]
[K]
[F]
[E]
[J]
[I]