Ricoh FT5233 Service Manual page 798

12 February 1992
6.3 TRAY UNIT DRIVE AND PAPER FEED CLUTCH
REPLACEMENT
[A]
[C]
[B]
[D]
1. Remove the copier and tray unit rear covers.
2. Remove the harness bracket [A] (2 screws).
NOTE: When reinstalling the bracket, make sure that the screws are
firmly secured so that the protective earth between the copier
and the paper tray unit is maintained.
3. Remove the bearing holder bracket [B] (1 screw).
4. Remove the tray unit drive clutch [C] (1 E-ring and 1 connector).
NOTE: When reinstalling the clutch, make sure that the clutch stopper
groove [D] engages with the stopper.
5. Remove the stopper bracket [E] (1 screw).
6. Remove the paper feed clutch [F] (1 connector and 1 wire saddle).
NOTE: When reinstalling the clutch, make sure that the clutch stopper
pin [G] engages with the groove of the stopper bracket.
REPLACEMENT AND ADJUSTMENT
[A]
[F]
21