Ricoh FT5233 Service Manual page 174

12 February 1992
2.7.2 Installation Procedure
[A]
[F]
NOTE: The sorter adapter is required to transport copy papers from the
copier exit rollers to the sorter entrance guide plates. It is required
when the mini-sorter (A423), midi-sorter (A411), or sorter stapler
(A366) is installed.
CAUTION: unplug the copier power cord before starting the following
procedure.
1. Remove the copier rear cover [A] (remove 2 screws and loosen 2 screws)
and the left small cover [B] (2 screws).
2. Open the front door and pull out the 1st and 2nd (or the paper and
duplex) trays.
3. Remove the left and front side screws [C] of the front upper cover [D] and
remove the left cover [E] (5 screws).
4. Remove the cover plate [F] from the left cover by cutting it with cutting
pliers.
5. Install the cover bracket [G] on the rear side frame as shown (1 screw).
[C]
[B]
[E]
3-27
COPIER INSTALLATION
[G]
[D]
[C]