Ricoh FT5233 Service Manual page 243

12 February 1992
[D]
[F]
[B]
[A]
<Rear side of the scanner drive belts>
2. Remove the PTL/QL stabilizer [A] (1 screw, 6 connectors, 2 wire saddles).
3. Swing out the main control board assembly [B] (1 screw).
4. Loosen the screws [C] for the tension brackets of the long and short
scanner drive belts (2 screws each).
5. Remove 2 tension springs [D].
6. Remove the scanner drive motor [E] (2 screws, 1 connector).
7. Remove the 3rd scanner home position sensor [F] (1 screw).
[C]
5-13
[D]
[C]
[E]
OPTICS