Ricoh FT5233 Service Manual page 827

INSTALLATION PROCEDURE
[B]
3. Remove the copier rear cover (remove 2 screws and loosen 2 screws).
4. Set the 2 locking supports [A] on the copier main board bracket [B] and
install the interface PCB [C] onto CN114 on the main board as shown.
5. Remove the plastic cap [D] and two lower screws from the copier left
cover as shown.
6. Install the front and rear connecting brackets [E], [F] on the copier as
shown (1 long and 2 short screws each).
7. Remove the sorter stapler rear cover (remove 3 screws, loosen 1 screw).
8. For now, install the fixing bracket [G] on the sorter stapler at the lowest
position (2 screws). (See step 12)
[C]
[A]
[G]
[D]
26
12 February 1992
[E]
[F]